Difference between revisions of "Tips on Using Imote2"
From Cyber-Physical Systems Laboratory
Jump to navigationJump to search| Line 1: | Line 1: | ||
* [http://sensorweb.vancouver.wsu.edu/wiki/index.php/Tinyos#Install_Imote2_in_tinyos-1.x Washington State University] has a great wiki with instructions on how to configure your platform to support the Imote2. | * [http://sensorweb.vancouver.wsu.edu/wiki/index.php/Tinyos#Install_Imote2_in_tinyos-1.x Washington State University] has a great wiki with instructions on how to configure your platform to support the Imote2. | ||
| + | * The Imote2 uses the FTDI USB chip whose drivers may be downloaded [http://www.ftdichip.com/Drivers/VCP.htm here]. | ||
* [[Toggling an External Pin on the Imote2]] | * [[Toggling an External Pin on the Imote2]] | ||
* When sending over UART, make sure the debug board is connected. | * When sending over UART, make sure the debug board is connected. | ||
* In TinyOS, TOS_LOCAL_ADDRESS is the last 2 digits of the mote id in hex | * In TinyOS, TOS_LOCAL_ADDRESS is the last 2 digits of the mote id in hex | ||
Revision as of 02:28, 24 January 2008
- Washington State University has a great wiki with instructions on how to configure your platform to support the Imote2.
- The Imote2 uses the FTDI USB chip whose drivers may be downloaded here.
- Toggling an External Pin on the Imote2
- When sending over UART, make sure the debug board is connected.
- In TinyOS, TOS_LOCAL_ADDRESS is the last 2 digits of the mote id in hex
